Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I'm working on creating cross sections and show the corridor in the section views. When I look at the corridor, I noticed that the offset assembly starts later than the one that along the mainline alignment. All the stationing matches up to each other so I don't understand why the offset assembly would start about 100' after the start station. Because of this, the cross sections does not show everything until on the third cross secitons view.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")