I recall someone else in this NG also was discussing this. Probably in the
last 2 weeks. The consensus was that there was a problem with arcs, as I
recall.
Bill
wrote in message news:5482539@discussion.autodesk.com...
I am pulling my hair out on this and need some help..
I created a General line label for some basic centerline dimensions and want
to use masking on them and noticed that the mask is not centered with the
label. See attached.
I turned on the border to see what is going on. I then noticed that the
label is not centered with the anchor point, but the border is. I have
double checked the styles for extra spaces and unusual formatting. I have
even created new styles from scratch...sam
e thing. I have checked most of the Standard styles, they all behave this
way. I have checked packaged tutorial dwgs, they are this way too.
I am not 100% sure, but seems like I didn't have this before. What am I
overlooking?