So I have a question... hope you have an answer.
Please see the attached image as it is probably the most clear way to show what I am looking for.
I am not sure how to tell the feature line to stop grading at the red line?
Solved! Go to Solution.
Solved by troma. Go to Solution.
Mark Green
Working on Civil 3D in Canada
That was the best fast response ever! I did not know there was a way to do that. I will have to write that down in my little book.
This is about what I was looking for. By keeping the ends of both lines at the same X, the points were almost all perpendicular to the red line, so not too bad. I wonder how it chooses where to place the elevations?
The command text that I found in Civil 3D 2013 is as follows:
ADJACENTFEATUREELEVSBYREF
THANK YOU!
Mark Green
Working on Civil 3D in Canada