Florin,
If your intent is only to create ditch lining and no subsurfaces - and if
this ditch design is not tied to any other centerline then perhaps you could
use some of the "generic subassemblies" such as LinkWidthAndSlope and/or
LinkSlopToSurface etc... to accomplish this. Bottom of ditch as centerline
as you explained is good too.
Of course there are many other ways to do it as other colleagues on this
forum can share.
Chakri
"Pamfi" wrote in message
news:18376684.1101819385110.JavaMail.jive@jiveforum2.autodesk.com...
> Hi,
> What is the best way to create a flat bottom ditch corridor?
> I have created an alignment from the centre of the bottom of the ditch and
then created an assembly with two basic lanes left and right and apply a
daylight general feature.
> Is this the best way of doing it?
>
> Thanks.
>
> Kind regards
>
> Florin