I have an alignment going up the center of a draw. I'd like to extract cross sections of this alignment and existing ground. What is a good way to do this?
I don't do cross sections very often, so when I need one, I draw a second alignment perpendicular to the first and profile that alignment to give me a bare bones cross section. I'd like to do these cross sections on a given interval, and at every change in direction. How should I go about it?
Thanks.
Solved! Go to Solution.
Solved by troma. Go to Solution.
My method....
I chose these from the menu bar, So be sure to have it turned on.
Create a profile 1st.
Sections>Create Sample Lines
Sections>Create Section View
Hopefully you have a Style created.
Good Luck,
Bo
In the create sample lines command there are options to create by station; where you click the location or type the station, or to create by range; where you set the start point, end point and the interval.
Mark Green
Working on Civil 3D in Canada
Can't find what you're looking for? Ask the community or share your knowledge.