AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
onsionsi1
Posts: 144
Registered: ‎10-19-2011
Message 1 of 3 (302 Views)

Daylight Overlapping issue

302 Views, 2 Replies
11-18-2012 06:57 AM

Hello There,

 

I faced some problem that the bench daylight intersect and overlap each other in some areas and also in view edit corridor section the link code for this daylight and other subassmbly didn't appear because there are some additional link code appeared at this view edit corridor section i don't know where it came from so this issue is clarifying in attached file.

 

Your advice please

Please do not forget approve as solutions and Points
to Remember Please Accept as Solution and Kudos Please
*Expert Elite*
mathewk
Posts: 2,720
Registered: ‎07-09-2003
Message 2 of 3 (294 Views)

Re: Daylight Overlapping issue

11-18-2012 07:26 AM in reply to: onsionsi1

Try an out of the box code set style in the section editor and you should see the daylight links.  Make sure the sectino editor is using that code set style, don't just apply it to your codrridor.

 

Regarding the overlaps, if your site is super steep, then the daylight will just keep going until it intersects the ground, overlap or not.  Especially with a curvy corridor such as yours.  Tough to say exactly if there is a problem without opening the file itself.   Thoush your section that shows across the entire site would indicate that this shouldn't happen.

Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Distinguished Contributor
onsionsi1
Posts: 144
Registered: ‎10-19-2011
Message 3 of 3 (286 Views)

Re: Daylight Overlapping issue

11-18-2012 08:00 AM in reply to: mathewk

Yes Mr. Math

 

My project is in super steep site but my issue is that i can't found the link code to edit and minimze distance that target the surface because there is appear additional link code and point code as appeared in attached file before.

 

Thank you.

Please do not forget approve as solutions and Points
to Remember Please Accept as Solution and Kudos Please

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D

Twitter

Facebook

Blogs