Community
I've been trying to incorporate a DEM into my EG surface. It is big but dont think it is overly large (about 1300 Acres - is that large?) It doesn't seem to want to be part of a DS. It incorporates in the parent surface without issue, but when I try to open the design file I get a fatal error. Does this happen to others out there?
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
There is no alignment issue. The DEM comes into my drawing NAD83 exactly where I expected it. The surface displays correctly and logically. The problem is if I try to DS the surface I get a fatal error.
When I opened in MicroDEM it said it was metric and out of curiosity I exported to kmz and I was in the Med. - the location issue is with me not knowing what MicroDEM is or how to use it intelligently (pardon me for not living up to your expectations, but just because I can grade drain, and design Hways doesn't make me a cartographer) 
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
It is a tiff. our GIS department exported to geo tiff from arcinfo. What exactly are you waiting for me to upload? the tiff is too big
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")