Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Cut and fill Are colculation using Quatity Takeoff Report

3 REPLIES 3
Reply
Message 1 of 4
Anonymous
148 Views, 3 Replies

Cut and fill Are colculation using Quatity Takeoff Report

Hi,
I still have a problem with area colculation using Quantity Takeoff report,
hi colculate the section areas, but I need the plan area 2D area like in
picture the area of black contours and the red contour in each ten meters,
the black contour mean fill the red contour means cut
Thanks
Darius
3 REPLIES 3
Message 2 of 4
Anonymous
in reply to: Anonymous

You need to generate a Volume Surface. Go to Surfaces in Prospector,
right-click and make a new one. Instead of a TIN, select Volume Tin, then
your two comparison surfaces. This new surface will let you apply the schema
you're after as a style.

HTH

--
James Wedding, P.E.
Technology Manager &
Associate
Jones & Boyd, Inc.
Dallas, TX
XP/2 on P4-3.4/1G
LDT 2006 & C3D2006/SP2
www.jones-boyd.com
www.ee2inc.com
Message 3 of 4
Anonymous
in reply to: Anonymous

The schema I generate, but I need the areas of each contuor color in 2d
like the red countor area from 1+00 to 1+10 is ...


"James Wedding" wrote in message
news:5053760@discussion.autodesk.com...
You need to generate a Volume Surface. Go to Surfaces in Prospector,
right-click and make a new one. Instead of a TIN, select Volume Tin, then
your two comparison surfaces. This new surface will let you apply the schema
you're after as a style.

HTH

--
James Wedding, P.E.
Technology Manager &
Associate
Jones & Boyd, Inc.
Dallas, TX
XP/2 on P4-3.4/1G
LDT 2006 & C3D2006/SP2
www.jones-boyd.com
www.ee2inc.com
Message 4 of 4
Anonymous
in reply to: Anonymous

So you need the area of each contour?

I hesitate to say this, but put an UNDO MARK in your drawing, then explode
the surface. When you have all the data you need, UNDO BACK to the
preexploded state.

Does that do it?

--
James Wedding, P.E.
Technology Manager &
Associate
Jones & Boyd, Inc.
Dallas, TX
XP/2 on P4-3.4/1G
LDT 2006 & C3D2006/SP2
www.jones-boyd.com
www.ee2inc.com

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report