Creating Pipe Trench

[nazerrul]

Hi guys.

I need some help on creating pipetrench1 on my surface.

Currently, I wanna make an alignment from a 16-inch pipe, which will then be positioned inside a trench.

I have tried several times to generate the corridor, but turned out failing.

Im guessing that i had inserted some parameters wrongly.

Here is the sample drawing:

https://www.dropbox.com/s/qn4gne9ebfgqqos/Sample.dwg

Can anyone please help me?

[dgordon]

first thing i noticed was that you don't have a region applied to the baseline in the corridor. After specifying a region i noticed that not very much of the corridor was being built so i looked at your profile. Your using and existing ground profile to build the corridor with instead of the bottom of the pipe or centerline of the pipe as shown in the assembly. Also, I would have expected the pipe to be in the ground a little deeper. You have the pipe half in and half out of the existing ground. The assembly your using has a daylight back to existing ground. The reason it's not generating very much is that your already starting and existing ground in most locations so it has no place to daylight to.