AutoCAD Civil 3D General

Active Member
Posts: 10
Registered: ‎08-23-2012
Message 1 of 3 (117 Views)


117 Views, 2 Replies
09-23-2012 04:26 PM

Hi there,


I created a corridor from a layout, and it connects to the alignment label below my surface.


Can someone help plesae, I don't know what to do.



*Expert Elite*
Posts: 4,496
Registered: ‎12-15-2008
Message 2 of 3 (115 Views)

Re: Corridor

09-23-2012 04:48 PM in reply to: sjka

Not Much to go on here, but if you mean it goes to zero then either shorten yoor corridor region a smidge or legthen your layout


Check out the posting tips video on the lower right of the DG page 1

Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram

Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
Active Member
Posts: 10
Registered: ‎08-23-2012
Message 3 of 3 (109 Views)

Re: Corridor

09-23-2012 05:11 PM in reply to: Joe-Bouza

Thanks, I will try that...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D