I have a basic roadway corridor with 2H:1V sideslopes. I am using the Link Slope to Surface subassembly to target the existing surface. However, the slopes aren't sloping the right way, they are sloping inward instead of outward. Please see attached image. I also snap shot the properties of the subassembly, I don't see what I am doing wrong. This has never happened before.
Solved! Go to Solution.
Can you post the drawing so that we can take a look at it?
Please use the Accept as Solution or Kudo buttons when appropriate
here's the file. the corridor in question is the drivewy on the WB side, around mainline station 13+25. The alignment and corridor name is DWY2. Thanks!
I am not sure how you did it but you need to remove the right and left alignments in Corridor Properties. Go to SET ALL TARGETS and remove both the left and right alignment where it is set next to Offset Alignment. If it reads <none> your sections seem to work OK.
okay, removing those target alignments did the trick...but I need those target alignments because the driveway width isn't constant...perhaps something else is wrong?
ah, it appears i mixed up my left and right target alignments! thank you for leading me in the right direction with removing those target alignments!
I just figured it out, myself. It has been at least 2 years since I last did one of these. THEN I remembered that the problem seems "BassAkwards"!!
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.