I have an alignement to which I have applied superelevation.
The superevation has been applied and the alignment has been annotation and it shows the change from camber to superelevation on the curves.
However when I create a surface of my corridor it does not show the superelevation, the surface is showing a cambered alignment throughout.
I have created a new alignment, a new corridor and surface and still the same.
Solved! Go to Solution.
Have you chosen a lane subassembly that supports superelevation and set "Use superelevation" parameters within that subassembly?
Please see attached
When creating the assembly I usually use crowned road and you can choose the slope (+ OR - 2% for me usually) or when choosing a lane you can also determine the slope. So build the Assembly on one side and then copy it over. then when I create my surface using top links it usually shows the crowned road top along my alignment.
Thats for this!
I had chosed the UKIE Carriageway, which I presumed would be ok.
When I check the settings box there was no option to change the working of the superelevation. There was one box that said superelevation with a number 6 after it. I presume this is a code.
I started again with a new assembly.
I used a standard DMRB template and adjusted it to suit my requirements, the carriageways on all these templates had the superelevation option which you showed.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.