I am doing intersections for the first time. When I build the intersection off of the two road corridors, the surface pulls to an elevation 0 in the curb turn fillets. Any clue what I may be doing wrong?
thanks
Hi,
you landed in the wrong forum, this here is for plain AutoCAD, you are speaking about Civil3D, so ask in the >>>forum for Civil3D<<<.
For that new thread please append the info, if that two corridors are in the same site or in different sites, imho that is important for answering your question.
Good luck, - alfred -
You are welcome! - alfred -
I setup two corridors for each proposed road based off of design profiles. I used assemblies that have been used and worked in the past and modified them for my streets. I was able to go to the next intersection and did not have the same problem. I checked the tie in point for the design profiles to make sure that wasnt throwing it off.