AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
JimShoes
Posts: 13
Registered: ‎03-07-2013
Message 1 of 2 (96 Views)

Corridor Assembly extent going crazy

96 Views, 1 Replies
06-18-2013 09:39 AM

HI all

 

I have put together an very basic assembly and now trying to create a corridor with it.

I selected the centreline (which looked to be nice and unifrm without stupid levels) as the alignment and I didnt use any target assignments. The resulting corridor had several section missing and one section snapped to 0,0,0 coordinate - see attached snapshot.

 

This looks to be an easy process but something is obviously not working. Thoughts anyone?

 

Thanks

*Expert Elite*
sboon
Posts: 2,089
Registered: ‎11-08-2005
Message 2 of 2 (50 Views)

Re: Corridor Assembly extent going crazy

06-18-2013 11:14 PM in reply to: JimShoes

I have seen video artifacts, where one of the corridor sections jumps to 0,0,0 in model view.  Try switching back to 2d plan view and see if the problem disappears.

 

The corridor parameters have options for setting the frequency of sections along tangents, curves, spirals etc.  If one of those values is set much higher than the others your corridor may appear to skip over portions of the alignment.

 

Steve
Please use the Accept as Solution or Kudo buttons when appropriate

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.