Can I Edit Pipe Elevations In a Table?

[rhdins]

I have a pipe network, and I would like to edit the elevations of multiple pipes, similar to how I would edit the elevations of a feature line or an alignment, in a table.  I can't figure out how to edit these besides just selecting pipe properties on each individual pipe.

Any help would be much appreciated.

[Jeff_M · Accepted solution]

Yes. Edit the network. On the network layout tools bar select the icon second from the right to open the vistas. There will be 2 tabs, one for pipes the other for structures.

[rhdins]

😮

[tadas.jan]

Hi,

in table you have change each pipe elevation manually. Is there any way to change entire network elevevation, for exmaple -0,2 for all. This would be useful in case of topology mistake, when it is needed to correct them by relative elevation -0,2. Change surface elevation is easy option, but how on pipe network? 

[Joe-Bouza · Accepted solution]

select all the pipes in the network and envoke the move command: at the command line enter 0,0,0 for the base point and 0,0,-.2 for the destination.
all your inverts will go down -.2

[tadas.jan]

Thanks, works..

[Joe-Bouza]

I'd like to give credit to Matt Anderson for that one.