C3D 2010, Win 7, 64 bit
The client is asking for a table of spot elevations every 20 feet for a 2500' project. They want it at curb lines and center of roadway, as well as the offsets since curb lines vary.
I can use my surface to get the elevations, but I would prefer to use my profile and superelevation in case the surface is wonky or gets changed accidentally.
Any suggestions? I have in the past written expressions, but it was a lot of work and required quite of bit of checking using the surface.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.