AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
rcallison
Posts: 69
Registered: ‎11-07-2012
Message 1 of 2 (67 Views)

Building an Assembly

67 Views, 1 Replies
02-01-2013 05:11 AM

I am building an assembly for a shoulder widening.  the sholder is 5' paved plus 5' stabalized tying to existing grade at a 4:1 slope.  The two shoulder sections are showing up in the cross section but the tie-down is not.  I have checked the target and it is set properly to the existing gound.

 

See below.

 

Thanks

 

DSGNRD03.jpg

Valued Mentor
fcernst
Posts: 1,093
Registered: ‎01-07-2011
Message 2 of 2 (64 Views)

Re: Building an Assembly

02-01-2013 05:17 AM in reply to: rcallison

Is your Daylight Slope steep enough to catch the surface, before just possibly projecting out to oblivion for a non-solution?

 

Check Code Set link styles for visibilty.

Fred Ernst, PE
C3D 2015
Ernst Engineering
www.ernstengineering.com
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.