AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
jak79
Posts: 119
Registered: ‎05-09-2008
Message 1 of 2 (103 Views)

2014 Structure table creation using Pipes

103 Views, 1 Replies
01-28-2014 05:08 AM

I am using C3D 2014. I have created a storm sewer pipe network and now I am working on creating a Structure Table found under the Pipes/add table menu. I have two types of structures (round and rectangular) both in the "Structure Size" column (see attached image). My question is if it's possible to format this column to display only the type of structure being used. What I end up with is "????" for the type of structure not being used. Any help or better practice is much appreciated.

 

Thanks

Valued Contributor
sirjoelsph
Posts: 58
Registered: ‎08-23-2006
Message 2 of 2 (67 Views)

Re: 2014 Structure table creation using Pipes

01-29-2014 07:06 AM in reply to: jak79

I asked a very similar question a while ago and we didn't come up with a specific answer but a few ideas on workarounds to try.  Take a look at this previous thread - http://forums.autodesk.com/t5/AutoCAD-Civil-3D-General/Structure-Label-Expression-Circular-vs-Rectan...

-JOEL
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.