AutoCAD Architecture

[#1]

Just out of the blue, inserting a door into a wall, any type of wall, the door gets inserted but the wall doesn't cut an opening. The wall still shows up going thru the opening of the wall. 'I've have tried display setting from Low Detail to Presentation with the same results. Anyone with some ideas on what's going on.

Thanks
Mike Message was edited by: mmyers

[#2]

Here is example of what I mean with the attached file.

[#3]

Are the sill lines turned on in the sill display rep?

Charlie


mmyers wrote:
> Here is example of what I mean with the attached file.
>
>
> ------------------------------------------------------------------------
>

[#4]

are both the door and wall at an elevation of 0?

[#5]

What Display Configuration is set current, and does the cut plane cut through the doors?

--

David Koch
Autodesk Discussion Group Facilitator
Using ADT 2004 at work; access to 2005, 2006, 2007 & 2008 at home

[#6]

Hi,

Can you attach a sample file with just one wall and door from the same file.if the actual file is not heavy, you can attach it directly.This will make it easy to solve the issue.

regards,
T

[#7]

I believe the sills are turn on. The cut plane is set to 0 and the doors don't cut thru and display setting. Here is the example file that you requested. Please let me know what you find out.

Thanks Message was edited by: mmyers

[#8]

your door is below the cut plane its only 8" tall.
wrote in message news:5677553@discussion.autodesk.com...
I believe the sills are turn on. The cut plane is set to 0 and the doors
don't cut thru and display setting. Here is the example file that you
requested. Please let me know what you find out.

Thanks

Message was edited by: mmyers

[#9]

Thanks

I really feel about 8" tall right now

Mike

[#10]

ahh, we've all been there in one way or another.


wrote in message news:5677795@discussion.autodesk.com...
Thanks

I really feel about 8" tall right now

Mike