AutoCAD Architecture General Discussion

Posts: 24
Registered: ‎04-06-2006
Message 1 of 1 (93 Views)

Wall Sweep Problem

93 Views, 0 Replies
01-04-2010 08:44 AM
I have a wall with a water table component to which I've attached a sweep. When I insert a door or window assembly that cuts through this component, I end up with a gap between the frame and water table. How do you eliminate this offset/gap between the water table (which has a sweep attached to it) and frames? The gap is the same distance as the chamfer of the water table. If the wall sweep is removed, the gap between the water table and door frame is eliminated. Is there a way to correct this and keep the sweep? I've attached a sample drawing (ACA 2010) showing this condition.

Thanks for any help,


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community