AutoCAD Architecture General

Reply
Member
Posts: 4
Registered: ‎11-01-2002
Message 1 of 5 (324 Views)

My ribbon is in gray and don't function until restart Architecture 2010

324 Views, 4 Replies
03-07-2010 10:28 PM
Frecuently my ribbon is in gray and don't function until restart Architecture 2010. It happen when I'm working, no moore than few minutes, and only my ribbon crash. I can work with command line, and the palettes , but don´t with ribbon.
*Dean Saadallah
Message 2 of 5 (324 Views)

Re: My ribbon is in gray and don't function until restart Architecture 2010

03-08-2010 05:13 AM in reply to: rmendezb
If you type RIBBON, does it come back?

--
Dean Saadallah
http://LTisACAD.blogspot.com
--
*Bill Gilliss
Message 3 of 5 (324 Views)

Re: My ribbon is in gray and don't function until restart Architecture 2010

03-08-2010 05:56 AM in reply to: rmendezb
On 3/8/2010 1:28 AM, rmendezb wrote:
> Frecuently my ribbon is in gray and don't function until restart Architecture 2010. It happen when I'm working, no moore than few minutes, and only my ribbon crash. I can work with command line, and the palettes , but don´t with ribbon.
>
Did you load the old ACA menus? I've had this problem, too. Usually I
can switch to a different workspace and then back.
*MarkB
Message 4 of 5 (324 Views)

Re: My ribbon is in gray and don't function until restart Architecture 2010

03-08-2010 02:52 PM in reply to: rmendezb
Sounds lile acad.cuix is loaded with aca.cuix. When both are loaded, mtext
text command causes the ribbon to grey out. Verify if mtext is causing this,
if so, get rid of acad.cuix.
This is discussed frequently in the newgroup, search for more information.
Mark

"Bill Gilliss" wrote in message
news:6350495@discussion.autodesk.com...
On 3/8/2010 1:28 AM, rmendezb wrote:
> Frecuently my ribbon is in gray and don't function until restart
> Architecture 2010. It happen when I'm working, no moore than few minutes,
> and only my ribbon crash. I can work with command line, and the palettes ,
> but don´t with ribbon.
>
Did you load the old ACA menus? I've had this problem, too. Usually I
can switch to a different workspace and then back.
Member
Posts: 4
Registered: ‎11-01-2002
Message 5 of 5 (324 Views)

Re: My ribbon is in gray and don't function until restart Architecture 2010

04-09-2010 10:05 PM in reply to: rmendezb
Thankyou.

Yes mtext is causing the trouble.
i recall workspace and the ribbon is enable again.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community