Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have attached a dwg using the out-of-the-box template and can't get the door tags to display properly even though the schedule reads correctly.
What's the trick to seeing the door numbers?
Thanks,
Adam
Hmmm, strange. When I open the drawing I see door 100, 101, 102 from left to right. Try releasing the door tag anchor and then re-anchor it to the door.
Edited by: jkrieg on Jun 16, 2009 9:37 AM
I'm open to suggestions. Perhaps I'll just switch to Revit. 🙂 It'd be funny if it weren't so annoying. Starting to wonder if a reinstall is the answer. When I did first install it was along side 2009, then uninstalled 2009. This has been usual M.O. though with new releases.
They show up fine for me. A reinstall or repair install seems to fix most
things for me.
wrote in message news:6202624@discussion.autodesk.com...
I'm open to suggestions. Perhaps I'll just switch to Revit. 🙂 It'd be funny
if it weren't so annoying. Starting to wonder if a reinstall is the answer.
When I did first install it was along side 2009, then uninstalled 2009. This
has been usual M.O. though with new releases.
Is this happening only in this drawing or any drawing in which you are placing door tags? You might try the command "objrelupdate" first before the repair/reinstallation.