Why does this always happen to parts? I know AutoCAD can't be this bugged for everybody or nobody would use it. Basically what happens is I make a model, save it, insert it into a new drawing and make arrangements of different parts. Randomly, I will insert something (like this part) that was totally fine and looked great even after I saved it and it will be all jacked up and parts of it wil be strewn all over the place with no discernable reason for it. When I delete the part and open the original part file I was trying to insert, it is all messed up just like it was once it was inserted. The attached picture is what it looks like in the original part file, no going back it's saved like that. If I move it in shaded view to the right spot it is wrong in wireframe and vice-versa. It is definitely not my PC's fault, gotta be the way I am drawing or the fact that I'm on a network drive that could have a low quality network or something. Any ideas?
Also it shows them selected in their original place, it just did this again to a different piece while this post was uploading...
If you have not done so already, you should log a support request with Autodesk with links to this and your other topic.
My first impression is that there's some 3rd party software affecting your 3D solids.
We've worked with your drawing here, and I've attached the results of our tinkering. I found that by exploding the solids, and then undo-ing the EXPLODE command, it did away with the alternate (invisible) content, and then I could move the remaining content into place. I unlocked everything and deleted the invisible blocks, which appeared to contain nothing anyway. Then I ran PURGE and -PURGE (for regapps) and the resultant file is zipped up and attached to this posting. Please let me know if it works for you upon opening it.
I have the same problem. Creating a multileaf spring, the 2 rear clips jumped out of place. If one selects these clips, you can notice a gost image with dashed lines on the places they were and should be. This is happening many times as I am making a cathalog using rendered images of springs. Please you help on this one.
It's the same kind of thing with this drawing. If you EXPLODE the solid and then UNDO the EXPLODE, the object will be all contained in the same spot again. I did that and repositioned the objects near where they were originally. There might be some slight inaccuracies with the placement, but that should be easy enough to correct.
If you explode the object, it will remain on the new position, not on the original position where it was supposed to be. So you have to move it back aproximately to the original position, it will not be a precise position. If later I intend to use this object on Mechanical, for loads and rate, I will find out the the "touching" object is no longer touching. And if the touching surface was generated by LOFT command, it will be impossible to uses solid snaps. So the Explode command may be a temporary solution until Autodesk gets a solution for this. Thanks anyway fo helping
EXPLODE > UNDO may provide some relief in that the objects don't have to be re-created, but it's not a solution. It's simply a method to eliminate the ghosting. It does not address the reason for the ghosting, or what caused the object to move from it's original location. I would hope the two drawings in this thread will be examined by Autodesk to identify and correct the source of the anomoly.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.