Community
AutoCAD Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

constraints removed

4 REPLIES 4
Reply
Message 1 of 5
m.pharamawy
303 Views, 4 Replies

constraints removed

hi everybody. i face a critical problem. in the attached file , this is a section , i used a collinear constraint to keep the levels attached to the lines which indecate them. now , if i copied the section with the levels . the constraints of some of the levels will be removed rondomly. i dont know why ?

please help

4 REPLIES 4
Message 2 of 5
nestly2
in reply to: m.pharamawy

I was not able to replicate your results.  I even used copy/paste to copy the 7 blocks to a new drawing and all the contraints seem to remain.   You have results different that what's shown below?

 

Copy-Constraints.gif

Message 3 of 5
m.pharamawy
in reply to: m.pharamawy

No I mean the copy command
Try to copy all the items by normal copy command.
One or two levels will not be constrainted anymore.
To make sure. After u copy them. Try to select only the section block and move it on y axis ( virtually ) some levels will not move with u.

Thanks for ur reply.
Message 4 of 5
m.pharamawy
in reply to: m.pharamawy

**vertically
Message 5 of 5
m.pharamawy
in reply to: nestly2

AS PER UR MOVIE SKETCH , I THINK THAT THE CONSTRAINTS OF SOME LEVELS HAD BEEN REMOVED. CHECK THAT AFTER MAKING COPY.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost