AutoCAD 2010/2011/2012

Reply
Active Contributor
Posts: 27
Registered: ‎08-13-2008
Message 11 of 12 (259 Views)

Re: navigating too many layout tabs

06-21-2011 02:07 PM in reply to: mathewk

Hi Mathewk,

I did consider the Sheet Set Manager but I didn't see a way to convert the layout tabs to a sheet set (granted, I didn't look all that hard at doing converting them).  We usually don't have that many layouts in our drawings and we have never had a need to use the Sheet Set Manager either.  A lot of our drawings are diagrammatic and are drawn in Modelspace - no need to set up paperspace and viewports on them.  But we also have structural and piping drawings that seldom need more than one layout tab and rarely more than 3.

 

In this case, we inherited the drawings from someone else and we're kind of stuck with the way they are set up.

 

I was getting irritated with having to scroll through 42 layout tabs.  Luckily, there's been a lot of great solutions out here that have made my life a bit easier. :smileyvery-happy:

 

Thanks for the tip anyway.

 

Don

*Expert Elite*
Posts: 2,616
Registered: ‎07-09-2003
Message 12 of 12 (255 Views)

Re: navigating too many layout tabs

06-21-2011 02:27 PM in reply to: donjacobsen
KLYPH, finally someone other than I is saying that :smileyhappy:
Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with AutoCAD

Twitter

Facebook

Blogs

Pinterest

Youtube