AutoCAD 2010/2011/2012

Reply
Member
Posts: 5
Registered: ‎08-25-2012
Message 1 of 2 (231 Views)

Quick Access Toolbar Customization

231 Views, 1 Replies
02-13-2013 10:01 AM

Hello,

 

I added the Layer group (On/Off Frreze Lock/ Unloack and Layer name) to the Quick Acess Toolbar. I only see the first part name of the layer. Is there a way to stretch this part of the group in the QAT tool bar so I can see the more of the layer name? Consensus of mny co-workers is no. 

 

I'm at a new job so perhaps the partial name and layer color may be a sufficient clue as to the whole layer name over time. Would be nice to see the whole name until then.

 

Thanks!

 

C/S

Many men go fishing all their lives without knowing it is not fish they are after.
Distinguished Contributor
Posts: 140
Registered: ‎06-09-2007
Message 2 of 2 (206 Views)

Re: Quick Access Toolbar Customization

02-15-2013 05:34 AM in reply to: Central_Standard

Open the CUI (type "CUI") and change the minimum width as shown on the attached.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with AutoCAD

Twitter

Facebook

Blogs

Pinterest

Youtube