AutoCAD 2010/2011/2012

New Member
Posts: 1
Registered: ‎12-04-2012
Message 1 of 1 (325 Views)

Object Snap to one layer in rotated XREF not working

325 Views, 0 Replies
12-04-2012 11:35 AM

Hi everyone,

I have an interesting problem I have not seen before.  I'm using AutoCAD 2011.


When using object snap to lines in an xref, I'm finding that I cannot snap to one particular layer in the XREF if and only if the XREF is rotated.  If it is at zero rotation, object snap works perfectly for all layers.  After rotating, I can no longer snap to the one particular layer in question.  If I rotate it back to zero rotation, snap works again.  That layer is nested a couple of xref's deep, but other layers from the same file snap just fine.


Any ideas?


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Connect with AutoCAD