AutoCAD 2010/2011/2012

New Member
Posts: 1
Registered: ‎03-22-2012
Message 1 of 2 (103 Views)

Block Attributes Help

103 Views, 1 Replies
03-22-2012 07:40 AM



I am trying to add a set of attribute data to a block that already exists within a drawing.


I was wondering if anyone could help me with this process


Thanks in advance.

*Expert Elite*
Posts: 880
Registered: ‎03-15-2008
Message 2 of 2 (74 Views)

Re: Block Attributes Help

03-22-2012 03:40 PM in reply to: NCFC_1862

If you haven't added the attributes to the block yet it's pretty easy.  All you need to do is open the block editor and define them right there.  Then type ATTSYNC and use the name of the block to make sure the changes are sync'd to the blocks in your drawing.  Then it's the same as if the attributes had already been set up.  Double click the block and the prompts for entering the attribute data should come up allowing you to input data.



Dave Hein, P.E.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community

Connect with AutoCAD