AutoCAD 2010/2011/2012

Reply
Member
arran.riley
Posts: 3
Registered: ‎11-28-2011
Message 1 of 2 (133 Views)

Auto CAD 2012

133 Views, 1 Replies
12-11-2011 09:35 AM

just installed auto cad 2012 service pack 1, running on HP Laptop with 6gb ram, 64-bit.

Installed fine, however when drawing there is a lot of lag when moving the mouse/cursor. This has been working on a prvious install on the same laptop. any help would be greatful.

 

Arran

*Expert Elite*
Alfred.NESWADBA
Posts: 8,893
Registered: ‎06-29-2007
Message 2 of 2 (132 Views)

Re: Auto CAD 2012

12-11-2011 09:47 AM in reply to: arran.riley

Hi,

 

sometimes after installation of servicepacks the settings of the hardware acceleration are in some indifferent state.

So start command _3DCONFIG ==> button "Manual tune" ==> deactivate hardware accerleration, close the dialog with OK, reopen it and set it back to ON (if it was ON before,at least invert the state 2 times).

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community




Connect with AutoCAD

Twitter

Facebook

Blogs

Pinterest

Youtube