Win 7 64 bit, AC 2012 full ver.
Whenever I have 2 dwgs open, coping from one to another, when I close the file I no longer need, AC gets a fatal error and crashes.
Do I need to reinstall, or is there a fix for this?
It's difficult to give you an answer based on that information. From what you are describing it sounds drawing specific. If it is drawing specific try the maintenance procedures described in TS18809891.
Let us know how that works or if we need to look at this from another angle.
I wanted to check back with you to see if the instructions I sent help?
I normally frequent the AC Electrical forum but I am here to ask a question and saw this thread. This is a common occurance with AC Electrical. It will happen often if I close drawings with the CLOSE ALL command.
If I close the drawings one at a time the problem is almost reduced.
Ifeel the cross hairs are returned before the file is fully saved but I waitfor the disk to stop accessing before I go to the next task.
Do the Ac support folks talk to the ACE support folks? I hope so.
I will start a new threas for my question.
Cheers John QUigley
Thanks for that feedback. It does appear that this is more of a core AutoCAD issue for which I do not have an answer at this time. I am submitting feedback about this problem to the development team.
Thank you for letting us know about the problem.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.