I have a problem in polyline width. when i set polyline width in one drawing shows solid line & in another drawing shows blank lines. please help.
Solved! Go to Solution.
Blank as in you can't see the line at all or it looks like an empty rectangle? If it looks like an empty rectangle, check "fillmode", make sure it set to 1 and not 0.
I have the same problem, but my PLINEs are empty only on the LAYOUT, not on the MODEL.
I tried changing FILLMODE to 0 and then REGEN and then to 1 again and REGEN, but it didn't work.
Thank you for the answer.
The UCS view is already set to TOP and it still doesn't work, I don't know what to do anymore.
When I plot from the model, the PLINEs are "fat", but when I plot from the layoit they are shallow!
can you upload this drawing (including that polyline and the layout)?
- alfred -
here is the file, thank you for the help!
as I'm not uploading the xref files, you can only see the margins and stuff and the PLINEs inside the viewports.
go into the viewport (and unlock it), run command _PLAN and then <ENTER> for commiting "current ucs". Now you have to correct the zoom-factor and .... polylines are filled again.
What happend? Any of your commands/actions rotated the view a little bit. And thick polylines that are not displayed parallel to their creation-plane are not visualized in filled mode.
HTH, - alfred -
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.