AutoCAD 2010/2011/2012 DWG Format

[#1]

Otrack doesn't seem to work no matter what I try. I've checked all the options and of course have otrack selected as active but no little indicator appears when I hover over a point and no vector appears when I move the crosshairs away.

Any suggestions?

[#2]

Might be a dumb question, but do you have a command active?

[#3]

yes.

It seems like a glitch. I used otrack all the time with 2011. I just upgraded to 2012 and otrack hasn't worked at all. Polar tracking works just fine though.

[#4]

Have had a lot of funny stuff happen but the otrack has performed reliably. Osnaps on?

[#5]

You have running OSnaps turned on, right?

[#6]

Osnap is on

[#7]

Try switching to a different profile to see if it works there, then switch back and check your primary profile

[#8]

Does changing the TRACKPATH setting help?

[#9 · Accepted solution]

Options, Drafting, Alignment Point Acquisition, pick automatic

[#10]

That did it! Thanks a ton. I thought I had tried that already but I guess not. Thanks