AutoCAD 2010/2011/2012 DWG Format

[#1]

The icons on my osnap toolbar do not coincide with the commands.  Any quick fixes??

[#2]

Not sure If I understand your problem

OSNAP  are not commands as such. When selecting an OSNAP Icon

it is expecting you to select an objects snap points. IE  EndPoint, Mid Point,

Intersection, Center, Quadrant, Nearest, Tangent, Perpendicular, Node. etc.

Hope this helps

Ron

[#3]

Thanks Ron for the quick response.

When I hover over any one of the icons, the discription window that opens does not match.  For instance, hovering over the "center" icon gives me "snap to quadrant".  The same is true with every icon on that toolbar.  I have not experienced this with any other toolbar. 

[#4]

Restart AutoCAD and see if the problem goes away: if it happens to one toolbar, it should be happening to ALL toolbars, unless someone coded your toolbar incorrectly when customizing.

[#5]

After restarting several times, no change. The toolbar is the standard one.

[#6]

CUI command, access the toolbar in question and look at each entry's details: if it's coded incorrectly you will see it there. Post a screenshot of the toolbar in CUI with a Osnap selected showing the error if you cannot decipher it.

[#7]

This is a wild suggestion. Did you change the font size in your windows to make the font larger. If yes, set the font size back to 100% and check.

[#8]

Thanks all for the suggestions.  I checked CUI and everthing looked fine.  Selected 'NODE' to look specifically at it and everything appeared fine.  Applied it to the 'node' icon,  even though it was already assigned, then hit apply at the bottom of the screen.  Toolbar corrected.  Don't understand, but it worked.