Distinguished Contributor
Posts: 126
Registered: ‎02-09-2012
Message 1 of 5 (156 Views)

# Dividing

156 Views, 4 Replies
09-05-2012 02:10 PM

So simple yet so annoying.

I have a line I want to divide evenly. At each line I want to put a 2x2 square. When I place the square at the created divided points the spacing inbetween is consistent but the two end modulars are larger.

What is the best way to make sure the spacing is the same on both sides of each square?

Hope that makes sense.

*Expert Elite*
Posts: 2,130
Registered: ‎12-11-2003
Message 2 of 5 (152 Views)

# Re: Dividing

09-05-2012 03:05 PM in reply to: amflasf

Evenly spaced from center of box to center of box.

Or from one edge of box (say, left side) to the other's

left side of box. The nodes created shall reference

the same point of the boxes that are in between.

???

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.
Distinguished Contributor
Posts: 126
Registered: ‎02-09-2012
Message 3 of 5 (150 Views)

# Re: Dividing

09-05-2012 03:21 PM in reply to: scot-65

I was doing it center of box to center of box.

This obviously doesn't work with the two outter edges of the box as it is off half the box distance from the dimension from center to center.

I want to get each to be spaced perfectly so maybe it is a matter of left side of box to left side of box.

I don't know cause I don't know how to use the divide command to get that percise.

Valued Mentor
Posts: 495
Registered: ‎05-11-2009
Message 4 of 5 (138 Views)

# Re: Dividing

09-05-2012 10:30 PM in reply to: amflasf

Someone else will no doubt prove me wrong but it doesn't work that way, add up the total length of the boxes, subtract that from the length of your line, and divide the remainder by the number of blocks +1, and that will give you the distance between the blocks.

Regards Steven Gray
Setting Out (Joinery Manufacturing)
Windows 7 professional
*Expert Elite*
Posts: 2,130
Registered: ‎12-11-2003
Message 5 of 5 (124 Views)

# Re: Dividing

09-06-2012 03:16 PM in reply to: amflasf

Scot-65
Dyslexia is a permanent physical disability that cannot be seen.

### You are not logged in.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

### Maintenance Subscription Resources

Upgrading to a 2015 product? Make sure to check these out 1st!