Assuming you don't have differences in you dimstyles, you could try "copy"
then "paste as block" from the edit pulldown.
"Frank van Haarlem" wrote in message
Did you try DIMDISASSOCIATE ?
"rcmike76" schreef in bericht news:email@example.com...
Okay I have been just dealing with this for a while but it is just getting
to be completely annoying.
When I copy a drawing from one place and paste it into another drawing the
dimensions just go out of whack. The points at which the nodes of the
dimension lines are not on the end points they are suppose to be on. They
are stretched all over the place and I have to go in and fix them everytime.
Is there a setting to stop this?