I have a drawing with a lot of polylines used as contours. Each polyline is given an elevation by 2's between 646 and 1088. I would like to use Quick Select (or any other appropriate command) to select ALL polylines with an elevation on the ten's (650, 660, 670, etc.) so I can change the layer of only those polylines. Any suggestions? I have been using Quick Select to do this, but changing each elevation individually takes a while.
So...I just quasi taught myself FILTER since I had seen the topic floating around other posts and it did the job for me. I wish it were still a bit more streamlined so I don't have to enter in each little item. I'm sure there's a LISP for that. (No iPod pun intended).
If anyone knows of a way that is better than FILTER to do what I'm trying, please share!
I guess I would have one other question though....
Is there any way to copy a filter from one drawing to another? I took the time to write one up for this contour drawing I have, but I need to use it on a few other drawings and would prefer not to rewrite it all.