Community
AutoCAD Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

"Fillet" and "Chamfer" command not working

2 REPLIES 2
Reply
Message 1 of 3
shermanjwilson
2664 Views, 2 Replies

"Fillet" and "Chamfer" command not working

Recently, a 2006 cad drawings was opened by a 2012 cad user and saved. Then it was saved "down" to a 2004 format. After I opened it again, I get a ton of "ARX Error" and the "Fillet" and "Chamfer" commands do not work anymore. I have to use trim instead of fillet. Is there anyway to fix this?

2 REPLIES 2
Message 2 of 3
Patchy
in reply to: shermanjwilson

You should reply to the 1st post you asked, it 's difficult to tell if the problem you have is autocad or the drawing file.

 

 

Message 3 of 3
pendean
in reply to: Patchy

You use ADT2006, correct?
YOu committed the ultimate sin by opening the saving the file in 2012: ALL aec content got upgraded and removed from ADT2006's access.

There is no fix, it is by design. It does not matter how far back you save down to: you ight be able to fix part of the problem if you don't care much about the content type by using -EXPORTTOAUTOCAD command in 2012 to knock the file down to AutoCAD-only object types (no ADT content).

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost