Alias General Discussion

Reply
Contributor
digiformer
Posts: 20
Registered: ‎08-19-2006
Message 1 of 4 (100 Views)

Stitch an hollow volume

100 Views, 3 Replies
08-28-2008 09:25 AM
Is it possible to get a completely closed but still hollow geometry stitched? Like a ball with material thickness but no hole in it.

So far i miserably fail on that challenge :smileyhappy:

Tobias
Contributor
digiformer
Posts: 20
Registered: ‎08-19-2006
Message 2 of 4 (100 Views)

Re: Stitch an hollow volume

08-28-2008 09:27 AM in reply to: digiformer
uh..aehm...sorry, could some admin move this one to the modeling section? ...my fault...

Thank You,
Tobias
Active Contributor
tekbot
Posts: 35
Registered: ‎07-18-2008
Message 3 of 4 (100 Views)

Re: Stitch an hollow volume

08-28-2008 09:41 PM in reply to: digiformer
i think stitching is a edge based thing. no edges on a ball with part thickness.

try Inventor.
Contributor
digiformer
Posts: 20
Registered: ‎08-19-2006
Message 4 of 4 (100 Views)

Re: Stitch an hollow volume

09-01-2008 06:43 AM in reply to: digiformer
started this one new in the modeling section...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community